| All about new cars |
 |
| Looking for a used car ? |
|
| Want to sell your car ? |
|
| Car Pooling |
|
| |
|
Enlist for carpooling in
|
|
|
| |
|
Search for carpools in
|
|
|
| Car Rentals |
|
| Refer Site To A Friend |
|
|
|
| Know Your Car : Fuel Injection System |
For most of the existence of the internal combustion engine, the carburetor has been the device that supplied fuel to the engine. On many other machines, such as lawnmowers and chainsaws, it still is.
But as the automobile evolved, the carburetor got complicated, trying to handle all the operating requirements. For instance, to handle some of these tasks, carburetors had 5 different circuits :
Main Circuit : Provides just enough fuel for fuel-efficient cruising.
Idle Circuit : Provides just enough fuel to keep the engine idling.
Accelerator Pump : Provides an extra burst of fuel when the accelerator pedal is first depressed. This reduces any hesitation before the engine speeds up.
Power Enrichment Circuit : Provides extra fuel when the car is going up a hill or towing a trailer.
Choke : Provides extra fuel when the engine is cold, so that it will start.
In order to meet stricter emissions requirements, catalytic converters were introduced. Very careful control of the air-to-fuel ratio was required for the catalytic converter to be effective. Oxygen sensors monitor the amount of oxygen in the exhaust, and the engine control unit (ECU) uses this information to adjust the air-to-fuel ratio in real-time. This is called closed loop control.
It was not feasible to achieve this control with carburetors. There was a brief period of electrically controlled carburetors before fuel injection systems took over, but these electrical carbs were even more complicated than the purely mechanical ones.
At first, carburetors were replaced with throttle body fuel injection systems (also known as single point or central fuel injection systems) that incorporated electrically controlled fuel-injector valves into the throttle body. These were almost a bolt-in replacement for the carburetor, so the automakers didn't have to make any drastic changes to their engine designs.
Gradually, as new engines were designed, throttle body fuel injection was replaced by multi-port fuel injection (also known as port, multi-point or sequential fuel injection). These systems have a fuel injector for each cylinder, usually located so that they spray right at the intake valve. These systems provide more accurate fuel metering and quicker response.
|
| <<< Previous | Next >>> |
|
|
|
 |
All about new bikes |
|
Buy / sell used bikes |
|
Message Boards |
|
Useful Stuff |
|
Know Your Car |
|
Your Opinion |
What is most urgently needed for Mumbai's Central Railway (local) train system ?
|
|
