| All about new cars |
 |
| Looking for a used car ? |
|
| Want to sell your car ? |
|
| Car Pooling |
|
| |
|
Enlist for carpooling in
|
|
|
| |
|
Search for carpools in
|
|
|
| Car Rentals |
|
| Refer Site To A Friend |
|
|
|
| Know Your Car : Car Steering |
Rack and pinion steering is quickly becoming the most common type of steering on cars, small trucks and utility vehicles. It is actually a pretty simple mechanism.
A rack and pinion gearset is enclosed in a metal tube, with each end of the rack protruding from the tube. A rod, called a tie rod, connects to each end of the rack.
The pinion gear is attached to the steering shaft. When you turn the steering wheel, the gear spins, moving the rack. The tie rod at each end of the rack connects to the steering arm on the spindle.
The rack-and-pinion gearset does two things :
- It converts the rotational motion of the steering wheel into the linear motion needed to turn the wheels.
- It provides a gear reduction, making it easier to turn the wheels.
On most cars, it takes three to four complete revolutions of the steering wheel to make the wheels turn from lock to lock (from far left to far right).
The steering ratio is the ratio of how far you turn the steering wheel to how far the wheels turn. For instance, if one complete revolution (360 degrees) of the steering wheel results in the wheels of the car turning 20 degrees, then the steering ratio is 360 divided by 20, or 18:1. A higher ratio means that you have to turn the steering wheel more to get the wheels to turn a given distance. However, less effort is required because of the higher gear ratio.
Generally, lighter, sportier cars have lower steering ratios than larger cars and trucks. The lower ratio gives the steering a quicker response - you don't have to turn the steering wheel as much to get the wheels to turn a given distance - which is a desirable trait in sports cars. These smaller cars are light enough that even with the lower ratio, the effort required to turn the steering wheel is not excessive.
Some cars have variable-ratio steering, which uses a rack and pinion gearset that has a different tooth pitch (number of teeth per inch) in the center than it has on the outside. This makes the car respond quickly when starting a turn (the rack is near the center), and also reduces effort near the wheel's turning limits.
Power Rack And Pinion
When the rack and pinion is in a power steering system, the rack has a slightly different design.
Part of the rack contains a cylinder with a piston in the middle. The piston is connected to the rack. There are two fluid ports, one on either side of the piston. Supplying higher-pressure fluid to one side of the piston forces the piston to move, which in turn moves the rack, providing the power assist.
We'll study the components that provide the high-pressure fluid, as well as decide which side of the rack to supply it to, in a later section. But before that, let's take a look at another type of steering.
|
| <<< Previous | Next >>> |
|
|
|
 |
All about new bikes |
|
Buy / sell used bikes |
|
Message Boards |
|
Useful Stuff |
|
Know Your Car |
|
Your Opinion |
What is most urgently needed for Mumbai's Central Railway (local) train system ?
|
|
